Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Arthur Martin C3
FAQ TREEWhat does error code C3 mean on a Arthur Martin appliance?
Arthur Martin error code C3 indicates: Arthur Martin ASF Series / Calypso / Electrolux Luxe Dishwasher: AquaControl flood protection active C3 (legacy DIVA alphanumeric); base float switch raised, continuous drain..
What is the root cause of Arthur Martin error code C3?
The primary root cause for Arthur Martin code C3 is: On Arthur Martin (Arthur Martin ASF Series / Calypso / Electrolux Luxe Dishwasher) models: Internal water leakage into bottom tray, loose hose clamp on sump or circulation pump, split tub bellow, or leaking dispenser gasket..
How do I fix or resolve Arthur Martin error code C3?
To resolve error code C3: Unplug dishwasher and shut water tap. Mop up all water from bottom drip tray. Inspect hoses under pressure to locate and repair leak. Hold Départ/Pause and Option buttons firmly for 5 seconds until the red indicator extinguishes and service memory resets.
Is it safe to clear Arthur Martin error code C3 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Arthur Martin code C3 persists, the physical component causing On Arthur Martin (Arthur Martin ASF Series / Calypso / Electrolux Luxe Dishwasher) models: Internal water leakage into bottom tray, loose hose clamp on sump or circulation pump, split tub bellow, or leaking dispenser gasket. must be inspected or replaced.
How do I test electrical resistance for Arthur Martin code C3 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Arthur Martin code C3?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



