Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Arthur Martin I50
FAQ TREEWhat does error code I50 mean on a Arthur Martin appliance?
Arthur Martin error code I50 indicates: Arthur Martin ASF Series / Calypso / Electrolux Luxe Dishwasher: Circulation wash pump motor general alarm i50; wash motor fails to circulate water through spray arms..
What is the root cause of Arthur Martin error code I50?
The primary root cause for Arthur Martin code I50 is: On Arthur Martin (Arthur Martin ASF Series / Calypso / Electrolux Luxe Dishwasher) models: Circulation pump motor capacitor failed (if single-phase), BLDC inverter stator winding open, jammed motor rotor, or triac/inverter driver fault..
How do I fix or resolve Arthur Martin error code I50?
To resolve error code I50: Measure motor winding resistance across phases (balanced 40–90 Ω on BLDC motor). Check run capacitor (~2.5–3.5 µF) if fitted. Ensure free rotation. Hold Départ/Pause and Option buttons firmly for 5 seconds until the red indicator extinguishes and service memory resets.
Is it safe to clear Arthur Martin error code I50 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Arthur Martin code I50 persists, the physical component causing On Arthur Martin (Arthur Martin ASF Series / Calypso / Electrolux Luxe Dishwasher) models: Circulation pump motor capacitor failed (if single-phase), BLDC inverter stator winding open, jammed motor rotor, or triac/inverter driver fault. must be inspected or replaced.
How do I test electrical resistance for Arthur Martin code I50 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test 3-Phase Motor Windings / Tacho Generator / Carbon Brushes across Across phase pins U-V, V-W, U-W on motor harness; across tacho pins. Expected nominal reading is 3Ω–6Ω (BLDC phase U-V-W) / 60Ω–180Ω (Tacho coil) / 1.5Ω–3.5Ω (Universal stator). Tolerance: BLDC phase winding values must be strictly balanced within ±0.3Ω. Hand rotation generates 1V–4V AC on tacho..
What safety protocol must be followed before servicing Arthur Martin code I50?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



