Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Arthur Martin F1
FAQ TREEWhat does error code F1 mean on a Arthur Martin appliance?
Arthur Martin error code F1 indicates: Arthur Martin ARA / ARB Series / Silentic Froid Refrigerator: Fresh food compartment air sensor failure F1; refrigerator compartment temperature regulation becomes erratic..
What is the root cause of Arthur Martin error code F1?
The primary root cause for Arthur Martin code F1 is: On Arthur Martin (Arthur Martin ARA / ARB Series / Silentic Froid Refrigerator) models: Refrigerator compartment NTC thermistor open or short circuit (~2.5 kΩ or ~5.0 kΩ at 25°C depending on platform), or moisture on sensor connector..
How do I fix or resolve Arthur Martin error code F1?
To resolve error code F1: Locate air sensor inside fresh food compartment. Measure resistance with multimeter (typically ~2.5 kΩ at 25°C, rising to ~5.9 kΩ at 4°C). Hold Départ/Pause and Option buttons firmly for 5 seconds until the red indicator extinguishes and service memory resets.
Is it safe to clear Arthur Martin error code F1 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Arthur Martin code F1 persists, the physical component causing On Arthur Martin (Arthur Martin ARA / ARB Series / Silentic Froid Refrigerator) models: Refrigerator compartment NTC thermistor open or short circuit (~2.5 kΩ or ~5.0 kΩ at 25°C depending on platform), or moisture on sensor connector. must be inspected or replaced.
How do I test electrical resistance for Arthur Martin code F1 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing Arthur Martin code F1?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



