Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bauknecht AL03
FAQ TREEWhat does error code AL03 mean on a Bauknecht appliance?
Bauknecht error code AL03 indicates: Bauknecht ProFresh & Dynamic0° Total NoFrost Refrigerator: Freezer compartment air ambient temperature sensor fault AL03; compressor runs continuously in emergency mode..
What is the root cause of Bauknecht error code AL03?
The primary root cause for Bauknecht code AL03 is: On Bauknecht refrigerators (Bauknecht Zen Motor Direct Drive brushless BLDC and L1373 / DEA700 power control architecture): Open circuit or shorted NTC thermistor bead, damaged wiring behind rear freezer wall, or main board ADC port defect..
How do I fix or resolve Bauknecht error code AL03?
To resolve error code AL03: Isolate electrical supply. Measure air probe resistance across main PCB connector: ~32 kΩ at -18°C, ~16 kΩ at 0°C. If open/short, replace sensor. Hold Alarm Reset button for 3 seconds until alarm indicator turns off and evaporator fan resumes normal cycle.
Is it safe to clear Bauknecht error code AL03 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bauknecht code AL03 persists, the physical component causing On Bauknecht refrigerators (Bauknecht Zen Motor Direct Drive brushless BLDC and L1373 / DEA700 power control architecture): Open circuit or shorted NTC thermistor bead, damaged wiring behind rear freezer wall, or main board ADC port defect. must be inspected or replaced.
How do I test electrical resistance for Bauknecht code AL03 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing Bauknecht code AL03?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



