Bompani E05

Bompani error code E05 indicates: Bompani Minimal / FlexInduction Touch Slider & Electronic Gas Hob: Operational diagnostic fault code E05 signaled by internal electronics. Mains AC supply under-voltage (<175 VAC RMS recorded under active induction load).

The primary root cause for Bompani code E05 is: On Bompani kitchen suites engineered with half-bridge resonant IGBT inverter modules, 100 kΩ coil NTC sensors, aluminum heatsink thermistors, 12V DC cooling fan, and thermoelectric flame supervision: Severe grid sag, loose supply terminal screw creating high resistance joint, or undersized wiring Multimeter diagnostic parameter: supply voltage must stay above 207 VAC RMS during full power booster activation across two cooking zones..

To resolve error code E05: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: tighten terminal screws and monitor Line-to-Neutral AC voltage with multimeter while increasing power levels. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Switch off mains power breaker for 2 minutes. Restore power, touch and hold Key Lock for 5 seconds until three beeps sound, verifying touch calibration resets.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code E05 persists, the physical component causing On Bompani kitchen suites engineered with half-bridge resonant IGBT inverter modules, 100 kΩ coil NTC sensors, aluminum heatsink thermistors, 12V DC cooling fan, and thermoelectric flame supervision: Severe grid sag, loose supply terminal screw creating high resistance joint, or undersized wiring Multimeter diagnostic parameter: supply voltage must stay above 207 VAC RMS during full power booster activation across two cooking zones. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.