Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bompani E19
FAQ TREEWhat does error code E19 mean on a Bompani appliance?
Bompani error code E19 indicates: Bompani Minimal / FlexInduction Touch Slider & Electronic Gas Hob: Operational diagnostic fault code E19 signaled by internal electronics. Induction cooling fan motor open circuit, rotor mechanically stalled, or tachometer pulse missing.
What is the root cause of Bompani error code E19?
The primary root cause for Bompani code E19 is: On Bompani kitchen suites engineered with half-bridge resonant IGBT inverter modules, 100 kΩ coil NTC sensors, aluminum heatsink thermistors, 12V DC cooling fan, and thermoelectric flame supervision: Dust accumulation or foreign object obstructing fan impeller, bearing seized, or BLDC driver failed Multimeter diagnostic parameter: 12V DC brushless fan coil resistance nominal 35 Ω to 55 Ω; tachometer generates 2 pulses per revolution..
How do I fix or resolve Bompani error code E19?
To resolve error code E19: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: spin fan blades manually to verify free rotation, then measure 12V DC delivery across fan power leads. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Switch off mains power breaker for 2 minutes. Restore power, touch and hold Key Lock for 5 seconds until three beeps sound, verifying touch calibration resets.
Is it safe to clear Bompani error code E19 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code E19 persists, the physical component causing On Bompani kitchen suites engineered with half-bridge resonant IGBT inverter modules, 100 kΩ coil NTC sensors, aluminum heatsink thermistors, 12V DC cooling fan, and thermoelectric flame supervision: Dust accumulation or foreign object obstructing fan impeller, bearing seized, or BLDC driver failed Multimeter diagnostic parameter: 12V DC brushless fan coil resistance nominal 35 Ω to 55 Ω; tachometer generates 2 pulses per revolution. must be inspected or replaced.
How do I test electrical resistance for Bompani code E19 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Bompani code E19?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?