Bompani E25

Bompani error code E25 indicates: Bompani Minimal / FlexInduction Touch Slider & Electronic Gas Hob: Operational diagnostic fault code E25 signaled by internal electronics. Gas burner flame failure safety thermocouple thermoelectric signal loss (<5 mV DC under flame).

The primary root cause for Bompani code E25 is: On Bompani kitchen suites engineered with half-bridge resonant IGBT inverter modules, 100 kΩ coil NTC sensors, aluminum heatsink thermistors, 12V DC cooling fan, and thermoelectric flame supervision: Thermocouple tip carbon encrusted, burner cap misaligned, tip bent away from flame, or copper lead broken Multimeter diagnostic parameter: thermocouple generated thermoelectric voltage nominal 18 mV to 28 mV DC when tip is heated in blue flame..

To resolve error code E25: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: connect multimeter in DC millivolt range between thermocouple center core and outer copper sheath under flame. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Switch off mains power breaker for 2 minutes. Restore power, touch and hold Key Lock for 5 seconds until three beeps sound, verifying touch calibration resets.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code E25 persists, the physical component causing On Bompani kitchen suites engineered with half-bridge resonant IGBT inverter modules, 100 kΩ coil NTC sensors, aluminum heatsink thermistors, 12V DC cooling fan, and thermoelectric flame supervision: Thermocouple tip carbon encrusted, burner cap misaligned, tip bent away from flame, or copper lead broken Multimeter diagnostic parameter: thermocouple generated thermoelectric voltage nominal 18 mV to 28 mV DC when tip is heated in blue flame. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.