Zanussi E25

Zanussi error code E25 indicates: Zanussi Lindo 100/300 / ZWF Front Load Washer: AquaStop / auxiliary drain circuit anomaly E25; safety drain relay or secondary drain sensing mismatch..

The primary root cause for Zanussi code E25 is: On Zanussi (Zanussi Lindo 100/300 / ZWF Front Load Washer) models: Micro-switch contacts oxidized on base float sensor, auxiliary pump triac damaged, or logic mismatch in dual-drain system..

To resolve error code E25: Inspect bottom drip tray for water and test float switch continuity (< 1 Ω closed). Check auxiliary relay contacts on main PCB. Hold Start/Pause plus Skip/Option button simultaneously for 5 seconds until three rapid confirmation beeps clear persistent error memory.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Zanussi code E25 persists, the physical component causing On Zanussi (Zanussi Lindo 100/300 / ZWF Front Load Washer) models: Micro-switch contacts oxidized on base float sensor, auxiliary pump triac damaged, or logic mismatch in dual-drain system. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.