Bompani E24

Bompani error code E24 indicates: Bompani Minimal / FlexInduction Touch Slider & Electronic Gas Hob: Operational diagnostic fault code E24 signaled by internal electronics. Gas burner electronic spark generator pulse module failure or ignition push-button switch shorted.

The primary root cause for Bompani code E24 is: On Bompani kitchen suites engineered with half-bridge resonant IGBT inverter modules, 100 kΩ coil NTC sensors, aluminum heatsink thermistors, 12V DC cooling fan, and thermoelectric flame supervision: Spark module high-voltage transformer secondary coil breakdown, moisture in microswitches, or shorted lead Multimeter diagnostic parameter: spark generator primary resistance nominal 1.2 kΩ to 1.8 kΩ at 20°C; pulse output >15 kV peak..

To resolve error code E24: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: measure resistance across spark module 230V input pins and test microswitch continuity during knob depress. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Switch off mains power breaker for 2 minutes. Restore power, touch and hold Key Lock for 5 seconds until three beeps sound, verifying touch calibration resets.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code E24 persists, the physical component causing On Bompani kitchen suites engineered with half-bridge resonant IGBT inverter modules, 100 kΩ coil NTC sensors, aluminum heatsink thermistors, 12V DC cooling fan, and thermoelectric flame supervision: Spark module high-voltage transformer secondary coil breakdown, moisture in microswitches, or shorted lead Multimeter diagnostic parameter: spark generator primary resistance nominal 1.2 kΩ to 1.8 kΩ at 20°C; pulse output >15 kV peak. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.