Bosch E11 — Dishwasher
[ACTIVE]Bosch Serie 4 / Serie 6 / Serie 8 ActiveWater & PerfectDry Zeolith: NTC temperature sensor fault E11; thermistor resistance signal open, shorted, or outside calibration limits.
On Bosch dishwashers: Defective NTC thermistor in heat pump or sump, corroded connector terminals, or broken signal lead in lower harness.
Measure NTC sensor resistance across pins (nominal ~10 kΩ at 20°C, ~4.9 kΩ at 40°C, ~2.5 kΩ at 60°C). Replace NTC sensor or heat pump assembly. Hold Start/Reset key for 3 seconds until '0:01' appears, close door, allow 60s for drain completion, then power off.



