Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bosch E13
FAQ TREEWhat does error code E13 mean on a Bosch appliance?
Bosch error code E13 indicates: Bosch Serie 4 / Serie 6 / Serie 8 ActiveWater & PerfectDry Zeolith: High water inlet temperature E13; intake water exceeds maximum design temperature limit (> 75°C)..
What is the root cause of Bosch error code E13?
The primary root cause for Bosch code E13 is: On Bosch dishwashers: Appliance accidentally connected to unmixed solar hot water or central heating loop exceeding 60°C, or faulty NTC..
How do I fix or resolve Bosch error code E13?
To resolve error code E13: Connect appliance to cold water supply or install thermostatic mixing valve set to max 60°C. Verify NTC resistance at ambient temperature (~10 kΩ at 20°C). Hold Start/Reset key for 3 seconds until '0:01' appears, close door, allow 60s for drain completion, then power off.
Is it safe to clear Bosch error code E13 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bosch code E13 persists, the physical component causing On Bosch dishwashers: Appliance accidentally connected to unmixed solar hot water or central heating loop exceeding 60°C, or faulty NTC. must be inspected or replaced.
How do I test electrical resistance for Bosch code E13 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Bosch code E13?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



