Bosch E23 — Dishwasher
[ACTIVE]Bosch Serie 4 / Serie 6 / Serie 8 ActiveWater & PerfectDry Zeolith: Drain pump winding resistance error E23; inverter reports open circuit, phase short, or coil defect in drain motor.
On Bosch dishwashers: Open or burnt winding in BLDC drain pump (nominal ~88 Ω across all 3 phases), or corroded 3-pin wiring harness connector.
Disconnect mains. Measure BLDC drain pump winding resistance (pins 1-2, 2-3, 1-3 should all read ~88 Ω ± 5%). Replace drain pump if values diverge. Hold Start/Reset key for 3 seconds until '0:01' appears, close door, allow 60s for drain completion, then power off.



