Bosch E6101

Bosch error code E6101 indicates: Bosch Serie 4 / Serie 6 / Serie 8 ActiveWater & PerfectDry Zeolith: Drain safety monitoring level anomaly E6101; electronic controller detects incorrect pressure signal during water evacuation..

The primary root cause for Bosch code E6101 is: On Bosch dishwashers: Clogged pressure chamber air hose in sump, non-return flap stuck partially open, or defective BLDC drain pump tachometer feedback..

To resolve error code E6101: Clean sump pressure transducer chamber using warm water syringe. Inspect rubber non-return flap. Check 3-phase resistance of BLDC drain motor (88 Ω). Hold Start/Reset key for 3 seconds until '0:01' appears, close door, allow 60s for drain completion, then power off.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bosch code E6101 persists, the physical component causing On Bosch dishwashers: Clogged pressure chamber air hose in sump, non-return flap stuck partially open, or defective BLDC drain pump tachometer feedback. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.