De Dietrich Er08

De Dietrich error code ER08 indicates: De Dietrich ICS (Intelligent Cooking System) / Fascination / Corium Pyrolytic Oven: Meat probe temperature sensor fault Er08; core food probe reads short-circuit or abnormal value when plugged into internal socket..

The primary root cause for De Dietrich code ER08 is: On De Dietrich built-in ovens featuring ICS sensor-guided automated culinary cooking, PT500 platinum thermal probe (~540 Ω at 20°C), and 480°C Pyro-Turbo cleaning: Internal jack socket grease contamination, punctured probe cable insulation, or damaged probe thermistor tip..

To resolve error code ER08: Unplug probe. Clean female jack receptacle inside oven with electronics cleaner. Measure resistance across probe plug pins with a multimeter. Rotate rotary knob to zero, disconnect power at the master breaker panel for 90 seconds, re-engage and validate time on the ICS interface.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if De Dietrich code ER08 persists, the physical component causing On De Dietrich built-in ovens featuring ICS sensor-guided automated culinary cooking, PT500 platinum thermal probe (~540 Ω at 20°C), and 480°C Pyro-Turbo cleaning: Internal jack socket grease contamination, punctured probe cable insulation, or damaged probe thermistor tip. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.