Sauter Er08

Sauter error code ER08 indicates: Sauter Saveurs / Confort / Amphora / SFP Pyrolytic Oven: Meat probe temperature sensor fault Er08; core food probe reads short-circuit or abnormal value when plugged into internal socket..

The primary root cause for Sauter code ER08 is: On Sauter built-in ovens featuring Saveurs gentle convection airflow, Conseil Température cooking guide, and Amphora enamel heat reflection: Internal jack socket grease contamination, punctured probe cable insulation, or damaged probe thermistor tip..

To resolve error code ER08: Unplug probe. Clean female jack receptacle inside oven with electronics cleaner. Measure resistance across probe plug pins with a multimeter. Turn selector to Off, drop power at the branch breaker for 60 seconds, restore supply and touch the clock icon to recalibrate.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Sauter code ER08 persists, the physical component causing On Sauter built-in ovens featuring Saveurs gentle convection airflow, Conseil Température cooking guide, and Amphora enamel heat reflection: Internal jack socket grease contamination, punctured probe cable insulation, or damaged probe thermistor tip. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.