Sauter F02

Sauter error code F02 indicates: Sauter Saveurs / Confort / Amphora / SFP Pyrolytic Oven: Temperature sensor probe short circuit F02; controller registers zero resistance on cavity thermal loop..

The primary root cause for Sauter code F02 is: On Sauter ovens featuring Saveurs gentle convection airflow, Conseil Température cooking guide, and Amphora enamel heat reflection: Pinch in braided high-temperature leads, crushed probe sheath touching cavity chassis, or internal short in RTD element..

To resolve error code F02: Disconnect sensor at PCB plug. Measure resistance across pins (must not be zero; nominal ~540 Ω at 20°C). Inspect wiring harness for chassis contact. Turn selector to Off, drop power at the branch breaker for 60 seconds, restore supply and touch the clock icon to recalibrate.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Sauter code F02 persists, the physical component causing On Sauter ovens featuring Saveurs gentle convection airflow, Conseil Température cooking guide, and Amphora enamel heat reflection: Pinch in braided high-temperature leads, crushed probe sheath touching cavity chassis, or internal short in RTD element. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.