Sauter Er03

Sauter error code ER03 indicates: Sauter Saveurs / Confort / Amphora / SFP Pyrolytic Oven: Tangential cooling fan motor tachometer fault Er03; oven aborts heating cycle because cabinet cooling airflow cannot be verified..

The primary root cause for Sauter code ER03 is: On Sauter built-in ovens featuring Saveurs gentle convection airflow, Conseil Température cooking guide, and Amphora enamel heat reflection: Jammed cross-flow fan wheel, seized sleeve bearings, disconnected Hall sensor harness, or open fan motor coil (~240–320 Ω)..

To resolve error code ER03: Spin tangential blower drum by hand to check for mechanical binding. Measure fan motor winding resistance (~240–320 Ω). Check 5V DC Hall sensor signal. Turn selector to Off, drop power at the branch breaker for 60 seconds, restore supply and touch the clock icon to recalibrate.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Sauter code ER03 persists, the physical component causing On Sauter built-in ovens featuring Saveurs gentle convection airflow, Conseil Température cooking guide, and Amphora enamel heat reflection: Jammed cross-flow fan wheel, seized sleeve bearings, disconnected Hall sensor harness, or open fan motor coil (~240–320 Ω). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test 3-Phase Motor Windings / Tacho Generator / Carbon Brushes across Across phase pins U-V, V-W, U-W on motor harness; across tacho pins. Expected nominal reading is 3Ω–6Ω (BLDC phase U-V-W) / 60Ω–180Ω (Tacho coil) / 1.5Ω–3.5Ω (Universal stator). Tolerance: BLDC phase winding values must be strictly balanced within ±0.3Ω. Hand rotation generates 1V–4V AC on tacho..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.