Sauter Er01

Sauter error code ER01 indicates: Sauter Saveurs / Confort / Amphora / SFP Pyrolytic Oven: Cavity temperature probe circuit open or shorted Er01; oven immediately halts cooking and beeps continuously..

The primary root cause for Sauter code ER01 is: On Sauter built-in ovens featuring Saveurs gentle convection airflow, Conseil Température cooking guide, and Amphora enamel heat reflection: Defective platinum RTD sensor probe (nominal PT500: ~540 Ω at 20°C, PT1000: ~1078 Ω at 20°C), or damaged ceramic lead wires..

To resolve error code ER01: Isolate mains breaker. Remove rear oven panel. Disconnect temperature sensor connector and measure resistance (~540 Ω at 20°C for PT500). Replace probe if open. Turn selector to Off, drop power at the branch breaker for 60 seconds, restore supply and touch the clock icon to recalibrate.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Sauter code ER01 persists, the physical component causing On Sauter built-in ovens featuring Saveurs gentle convection airflow, Conseil Température cooking guide, and Amphora enamel heat reflection: Defective platinum RTD sensor probe (nominal PT500: ~540 Ω at 20°C, PT1000: ~1078 Ω at 20°C), or damaged ceramic lead wires. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.