FAGOR d14

FAGOR error code D14 indicates: Fagor Eco Sensor / Innova / 1LV / 2LV Dishwasher: Wash pump cavitation / water fill discrepancy d14; circulation motor draws irregular current due to aerated water foam..

The primary root cause for FAGOR code D14 is: On FAGOR dishwashers featuring Eco Sensor turbidity optoelectronics, Innova hydraulic distribution, and AquaStop active leak containment: Hand dishwashing liquid added causing massive foaming, low water level, or partially siphoned drain..

To resolve error code D14: Pour 2 tablespoons of vegetable cooking oil into tub to suppress foam. Run drain cycle. Refill with cold water and check water level. Press and hold the Start/Stop key for 5 seconds until the program indicator light clears and drain pump runs, then switch off.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if FAGOR code D14 persists, the physical component causing On FAGOR dishwashers featuring Eco Sensor turbidity optoelectronics, Innova hydraulic distribution, and AquaStop active leak containment: Hand dishwashing liquid added causing massive foaming, low water level, or partially siphoned drain. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.