Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Favorit E34
FAQ TREEWhat does error code E34 mean on a Favorit appliance?
Favorit error code E34 indicates: Favorit ProCare / SwissWash High-Efficiency Electronic Washing Machine: Diagnostic fault code E34 registered by the microcomputer controller. Washing machine emergency anti-flooding overfill pressure switch level 2 contact closed (code E34).
What is the root cause of Favorit error code E34?
The primary root cause for Favorit code E34 is: On Favorit SwissLine and European precision appliances built for high durability engineered with Eco-Inverter BLDC direct drive motor (5.5-8.0 Ω per phase), 2100W heating element (24-27 Ω), 10 kΩ NTC thermistor at 25°C, pneumatic pressure switch with sealed air trap, and instant bi-metal door lock: water fill valve triac breakdown on power PCB, valve diaphragm seized mechanically open, or heavy foam column. Metrological tolerance verification: safety level 2 contact closes when pressure exceeds 2500 Pa (~250mm water column); forced drain pump active..
How do I fix or resolve Favorit error code E34?
To resolve error code E34: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: turn off water supply immediately, test fill valve voltage with power switch on, and check triac for short circuit. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn cycle selector to Stop. Hold Start/Pause and Eco buttons together for 5 seconds until display chimes and shows 'CLr', wiping diagnostic fault memory.
Is it safe to clear Favorit error code E34 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code E34 persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with Eco-Inverter BLDC direct drive motor (5.5-8.0 Ω per phase), 2100W heating element (24-27 Ω), 10 kΩ NTC thermistor at 25°C, pneumatic pressure switch with sealed air trap, and instant bi-metal door lock: water fill valve triac breakdown on power PCB, valve diaphragm seized mechanically open, or heavy foam column. Metrological tolerance verification: safety level 2 contact closes when pressure exceeds 2500 Pa (~250mm water column); forced drain pump active. must be inspected or replaced.
How do I test electrical resistance for Favorit code E34 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Favorit code E34?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



