Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Franke H05
FAQ TREEWhat does error code H05 mean on a Franke appliance?
Franke error code H05 indicates: Franke Mythos / Maris FlexPro Induction & Flush Glass Gas Cooktop: Diagnostic fault code H05 registered by the microcomputer controller. Motor speed electronic triac short circuit (blower runs only on max).
What is the root cause of Franke error code H05?
The primary root cause for Franke code H05 is: On Franke appliances engineered with FlexPro multi-coil induction generator with E.G.O. power electronics, continuous pan-tracking sensors, and optical thermal cutoff circuitry: motor speed triac shorted Metrological tolerance verification: triac resistance 0.0 Ω shorted...
How do I fix or resolve Franke error code H05?
To resolve error code H05: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: test motor control triac on hood power board. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Clean and thoroughly dry the glass surface. Disconnect main breaker for 2 minutes. Restore power and immediately press and hold the Key Lock sensor for 5 seconds until double acoustic confirmation sounds.
Is it safe to clear Franke error code H05 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Franke code H05 persists, the physical component causing On Franke appliances engineered with FlexPro multi-coil induction generator with E.G.O. power electronics, continuous pan-tracking sensors, and optical thermal cutoff circuitry: motor speed triac shorted Metrological tolerance verification: triac resistance 0.0 Ω shorted.. must be inspected or replaced.
How do I test electrical resistance for Franke code H05 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test 3-Phase Motor Windings / Tacho Generator / Carbon Brushes across Across phase pins U-V, V-W, U-W on motor harness; across tacho pins. Expected nominal reading is 3Ω–6Ω (BLDC phase U-V-W) / 60Ω–180Ω (Tacho coil) / 1.5Ω–3.5Ω (Universal stator). Tolerance: BLDC phase winding values must be strictly balanced within ±0.3Ω. Hand rotation generates 1V–4V AC on tacho..
What safety protocol must be followed before servicing Franke code H05?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?