Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: H-Koenig LDS-13
FAQ TREEWhat does error code LDS-13 mean on a H-Koenig appliance?
H-Koenig error code LDS-13 indicates: H.Koenig SWRC90 / SWRC110 / WaterMop Laser LDS Smart Robotic Vacuum & Mop: Diagnostic fault code LDS-13 registered by the microcomputer controller. Dock homing beacon infrared receiver sensor blind; robot cannot dock.
What is the root cause of H-Koenig error code LDS-13?
The primary root cause for H-Koenig code LDS-13 is: On H.Koenig appliances engineered with 360° laser LDS distance turret (5-8 Hz), twin DC wheel drive motors with encoders, 20W BLDC suction fan, and 14.8V 2600mAh lithium battery with thermal cut-off: dock IR beacon lens dirty, bright direct sunlight shining on dock, or IR receiver diode open Metrological tolerance verification: 38 kHz demodulated IR signal present at MCU GPIO pin during dock line-of-sight test..
How do I fix or resolve H-Koenig error code LDS-13?
To resolve error code LDS-13: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: relocate charge dock away from bright windows; wipe dark front IR window of robot and dock. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: turn off the mechanical master rocker switch under the chassis, clean optical cliff sensors and wheel hubs, place robot on charging dock, and hold Auto for 5 seconds.
Is it safe to clear H-Koenig error code LDS-13 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if H-Koenig code LDS-13 persists, the physical component causing On H.Koenig appliances engineered with 360° laser LDS distance turret (5-8 Hz), twin DC wheel drive motors with encoders, 20W BLDC suction fan, and 14.8V 2600mAh lithium battery with thermal cut-off: dock IR beacon lens dirty, bright direct sunlight shining on dock, or IR receiver diode open Metrological tolerance verification: 38 kHz demodulated IR signal present at MCU GPIO pin during dock line-of-sight test. must be inspected or replaced.
How do I test electrical resistance for H-Koenig code LDS-13 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test 3-Phase Motor Windings / Tacho Generator / Carbon Brushes across Across phase pins U-V, V-W, U-W on motor harness; across tacho pins. Expected nominal reading is 3Ω–6Ω (BLDC phase U-V-W) / 60Ω–180Ω (Tacho coil) / 1.5Ω–3.5Ω (Universal stator). Tolerance: BLDC phase winding values must be strictly balanced within ±0.3Ω. Hand rotation generates 1V–4V AC on tacho..
What safety protocol must be followed before servicing H-Koenig code LDS-13?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?