Haier F2 — Dryer
[ACTIVE]Haier I-Pro Series 7 / 9 Dual Inverter Heat Pump Dryer: Rear exhaust temperature sensor fault F2; exhaust air probe sends corrupted or out-of-range temperature signal.
On Haier dryers utilizing I-Pro Series Dual Inverter heat-pump circuit, sensor-dry thermistor array, and reverse-tumble motor control: Defective rear duct NTC thermistor, damaged sensor wire harness near heater chamber, or connector corrosion.
Check rear duct probe resistance (~10 kΩ–20 kΩ at 25°C). Inspect sensor lead routing to ensure no heat damage from rear element. Turn dial to Warm Air program, press Dry Level and Time Dry together for 5 seconds until beep sounds, then return to Power Off.



