Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Hoover AL03
FAQ TREEWhat does error code AL03 mean on a Hoover appliance?
Hoover error code AL03 indicates: Hoover H-DISH 300 / 500 / 700 Maxi Tub Smart Dishwasher: Drain evacuation alarm AL03; sump fails to empty completely during intermediate rinse drain phase..
What is the root cause of Hoover error code AL03?
The primary root cause for Hoover code AL03 is: On Hoover dishwashers powered by H-DISH Maxi Tub architecture, Triple Self-Cleaning micro-filtration wash system, and hOn Wi-Fi connectivity: Heavy grease clogs in drain hose, sink siphon nipple blocked, or drain pump motor winding weakened (~160–220 Ω)..
How do I fix or resolve Hoover error code AL03?
To resolve error code AL03: Disconnect drain hose from under-sink siphon and verify clear bore. Flush drain hose with warm water. Measure pump motor resistance (~160–220 Ω). Hold the Programme selector button and Start/Pause together for 6 seconds until all indicator LEDs light up, then power off.
Is it safe to clear Hoover error code AL03 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Hoover code AL03 persists, the physical component causing On Hoover dishwashers powered by H-DISH Maxi Tub architecture, Triple Self-Cleaning micro-filtration wash system, and hOn Wi-Fi connectivity: Heavy grease clogs in drain hose, sink siphon nipple blocked, or drain pump motor winding weakened (~160–220 Ω). must be inspected or replaced.
How do I test electrical resistance for Hoover code AL03 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Hoover code AL03?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



