Korting C01

Korting error code C01 indicates: Körting KHI / KHC PowerBoost FlexInduction & HiLight Ceramic Hob: Diagnostic fault code C01 registered by the microcomputer controller. Rear left induction cooking zone coil NTC thermistor sensor open circuit (>200 kΩ).

The primary root cause for Korting code C01 is: On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with E.G.O. induction generator, 100 kΩ surface thermistors at 25°C, IGBT switches with thermal compound, 12V DC cooling fan, and touch slider UI: thermistor bead wire fractured from thermal contraction, spring contact bent, or wiring connector loose. Metrological tolerance verification: nominal coil NTC resistance 100 kΩ at 25°C, 32.5 kΩ at 50°C; infinite resistance indicates open circuit..

To resolve error code C01: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: unplug sensor connector from induction generator board and measure coil NTC resistance (expect ~100 kΩ at 25°C). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Disconnect electrical supply at the fuse board for 90 seconds. Restore power, touch and hold Key Lock for 5 seconds until acoustic signal indicates calibration reset.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Korting code C01 persists, the physical component causing On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with E.G.O. induction generator, 100 kΩ surface thermistors at 25°C, IGBT switches with thermal compound, 12V DC cooling fan, and touch slider UI: thermistor bead wire fractured from thermal contraction, spring contact bent, or wiring connector loose. Metrological tolerance verification: nominal coil NTC resistance 100 kΩ at 25°C, 32.5 kΩ at 50°C; infinite resistance indicates open circuit. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.