Korting C06

Korting error code C06 indicates: Körting KHI / KHC PowerBoost FlexInduction & HiLight Ceramic Hob: Diagnostic fault code C06 registered by the microcomputer controller. Induction user interface touch board to power generator module LIN serial bus communication timeout.

The primary root cause for Korting code C06 is: On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with E.G.O. induction generator, 100 kΩ surface thermistors at 25°C, IGBT switches with thermal compound, 12V DC cooling fan, and touch slider UI: internal communication ribbon cable unplugged, broken data conductor, or auxiliary 12V DC power failure. Metrological tolerance verification: LIN serial bus active square wave logic pulses; auxiliary power rails +12.0V DC and +5.0V DC present..

To resolve error code C06: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: inspect ribbon cable for pin damage, verify continuity of each wire (<0.3 Ω) and measure +12V DC supply rail. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Disconnect electrical supply at the fuse board for 90 seconds. Restore power, touch and hold Key Lock for 5 seconds until acoustic signal indicates calibration reset.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Korting code C06 persists, the physical component causing On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with E.G.O. induction generator, 100 kΩ surface thermistors at 25°C, IGBT switches with thermal compound, 12V DC cooling fan, and touch slider UI: internal communication ribbon cable unplugged, broken data conductor, or auxiliary 12V DC power failure. Metrological tolerance verification: LIN serial bus active square wave logic pulses; auxiliary power rails +12.0V DC and +5.0V DC present. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.