Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: LG FREEZER DEFROST SENSOR ERROR
FAQ TREEWhat does error code FREEZER DEFROST SENSOR ERROR mean on a LG appliance?
LG error code FREEZER DEFROST SENSOR ERROR indicates: On LG Refrigerator: Freezer Defrost Sensor Error is displayed..
What is the root cause of LG error code FREEZER DEFROST SENSOR ERROR?
The primary root cause for LG code FREEZER DEFROST SENSOR ERROR is: On LG Refrigerator: Loose connection (CON7), defective D-Sensor, defective main PCB..
How do I fix or resolve LG error code FREEZER DEFROST SENSOR ERROR?
To resolve error code FREEZER DEFROST SENSOR ERROR: On LG Refrigerator: Reconnect CON7. If the same situation appears, disconnect CON7 and measure resistance (Pin3 & Pin4 of CON7, BO to BO, 6 ~ 300 Result). If abnormal, replace D-Sensor. If the same situation appears again, replace the main PCB.
Is it safe to clear LG error code FREEZER DEFROST SENSOR ERROR by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if LG code FREEZER DEFROST SENSOR ERROR persists, the physical component causing On LG Refrigerator: Loose connection (CON7), defective D-Sensor, defective main PCB. must be inspected or replaced.
How do I test electrical resistance for LG code FREEZER DEFROST SENSOR ERROR using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing LG code FREEZER DEFROST SENSOR ERROR?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



