Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: LG ICE MAKER KIT ERROR
FAQ TREEWhat does error code ICE MAKER KIT ERROR mean on a LG appliance?
LG error code ICE MAKER KIT ERROR indicates: Ice Maker KIT Error is displayed.. Diagnostic error code Ice Maker KIT Error reported on LG Refrigerator..
What is the root cause of LG error code ICE MAKER KIT ERROR?
The primary root cause for LG code ICE MAKER KIT ERROR is: On LG Refrigerator: Loose connection (CON13), defective Ice Maker module part in freezer room, defective main PCB..
How do I fix or resolve LG error code ICE MAKER KIT ERROR?
To resolve error code ICE MAKER KIT ERROR: On LG Refrigerator: Reconnect CON13. Inspect Ice Maker module part. Check voltage (between pins 9 and 10 of CON13, 5V ~ 12V). If abnormal, replace Ice Maker Unit. If the same situation appears again, replace the Main PCB.
Is it safe to clear LG error code ICE MAKER KIT ERROR by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if LG code ICE MAKER KIT ERROR persists, the physical component causing On LG Refrigerator: Loose connection (CON13), defective Ice Maker module part in freezer room, defective main PCB. must be inspected or replaced.
How do I test electrical resistance for LG code ICE MAKER KIT ERROR using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test PCB Power Supply Rails & DC Bus Filter Capacitors across Across SMPS output electrolytic capacitors on low-voltage side (test bench verification). Expected nominal reading is Low-voltage rails: +5.0V DC (Logic), +12.0V DC (Relays), +3.3V DC (MCU). Relay coils: 200Ω–450Ω.. Tolerance: DC rail ripple must remain <50mV. Direct continuity (0Ω) across DC bus rails indicates dead short..
What safety protocol must be followed before servicing LG code ICE MAKER KIT ERROR?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



