Neff E845

Neff error code E845 indicates: Neff N 50 / N 70 / N 90 Slide&Hide® & CircoTherm® Pyrolytic Oven with ShiftControl: Combi-steam boiler water level optical sensor calibration failure E845; steam generator cannot verify boiler water level..

The primary root cause for Neff code E845 is: On Neff ovens: Heavy lime scale coating optical refraction prism inside steam generator, defective optocoupler, or empty water reservoir tank..

To resolve error code E845: Run automatic oven descaling program with recommended descaling liquid. Remove boiler unit and clean optical glass prism. Verify water pump flow. Turn oven off, hold 'i' Info and Clock icons simultaneously on ShiftControl panel for 4 seconds, or cycle mains breaker.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Neff code E845 persists, the physical component causing On Neff ovens: Heavy lime scale coating optical refraction prism inside steam generator, defective optocoupler, or empty water reservoir tank. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.