Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Novomatic AL22
FAQ TREEWhat does error code AL22 mean on a Novomatic appliance?
Novomatic error code AL22 indicates: Novomatic GS / GSU Integrated & Freestanding Electronic Dishwasher Series: Diagnostic fault code AL22 registered by the microcomputer controller. Kitchen sink drain siphon spigot obstructed or knockout plug membrane not pierced.
What is the root cause of Novomatic error code AL22?
The primary root cause for Novomatic code AL22 is: On Novomatic Austrian and Central European retail OEM chassis appliances engineered with Austrian retail OEM wash system with 1800W flow tube element (27-31 Ω), wash motor (95-125 Ω), and pressure membrane switch: new kitchen sink installation with unpunched spigot knockout, or grease sludge clogging branch. Metrological tolerance verification: siphon spigot internal lumen diameter minimum 18 mm unblocked; backpressure 0 Pa..
How do I fix or resolve Novomatic error code AL22?
To resolve error code AL22: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: disconnect discharge hose from sink trap spigot, clear grease plug or punch out internal blanking membrane with screwdriver. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: press and hold the Program selector and Start buttons together for 5 seconds until the display beeps and drain pump evacuates remaining water.
Is it safe to clear Novomatic error code AL22 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Novomatic code AL22 persists, the physical component causing On Novomatic Austrian and Central European retail OEM chassis appliances engineered with Austrian retail OEM wash system with 1800W flow tube element (27-31 Ω), wash motor (95-125 Ω), and pressure membrane switch: new kitchen sink installation with unpunched spigot knockout, or grease sludge clogging branch. Metrological tolerance verification: siphon spigot internal lumen diameter minimum 18 mm unblocked; backpressure 0 Pa. must be inspected or replaced.
How do I test electrical resistance for Novomatic code AL22 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Novomatic code AL22?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?