Sauter d11

Sauter error code D11 indicates: Sauter Silence / SVH / Saveurs Built-in Dishwasher: Pressure switch chamber clogged d11; water column sensing membrane is sluggish or fails to return to zero..

The primary root cause for Sauter code D11 is: On Sauter dishwashers utilizing Saveurs alternating hydraulic wash arms, Flexi-Safe load geometry, and 42dB acoustic shielding: Heavy grease and food deposit coagulation inside the sump air bell chamber or kinked pressure tube..

To resolve error code D11: Flush sump air trap with hot water and degreasing agent. Detach pressure switch hose and blow through to clear blockage. Press and hold the Start/Reset button for 4 seconds until drain pump initiates, allow pumpout to complete, then switch off.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Sauter code D11 persists, the physical component causing On Sauter dishwashers utilizing Saveurs alternating hydraulic wash arms, Flexi-Safe load geometry, and 42dB acoustic shielding: Heavy grease and food deposit coagulation inside the sump air bell chamber or kinked pressure tube. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.