Sauter d01

Sauter error code D01 indicates: Sauter Silence / SVH / Saveurs Built-in Dishwasher: Water fill timeout d01; appliance fails to fill with adequate water volume within 4 minutes of program launch..

The primary root cause for Sauter code D01 is: On Sauter dishwashers featuring Saveurs alternating hydraulic wash arms, Flexi-Safe load geometry, and 42dB acoustic shielding: Closed water isolation cock, clogged aquastop filter mesh, or open inlet solenoid coil (~3.8 kΩ)..

To resolve error code D01: Inspect tap flow rate. Unscrew hose connection and clean the inline strainer. Measure aquastop solenoid resistance (~3.8 kΩ). Press and hold the Start/Reset button for 4 seconds until drain pump initiates, allow pumpout to complete, then switch off.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Sauter code D01 persists, the physical component causing On Sauter dishwashers featuring Saveurs alternating hydraulic wash arms, Flexi-Safe load geometry, and 42dB acoustic shielding: Closed water isolation cock, clogged aquastop filter mesh, or open inlet solenoid coil (~3.8 kΩ). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.