Sauter d08

Sauter error code D08 indicates: Sauter Silence / SVH / Saveurs Built-in Dishwasher: Alternating spray distributor valve motor fault d08; wash water does not alternate between upper and lower spray arms..

The primary root cause for Sauter code D08 is: On Sauter dishwashers featuring Saveurs alternating hydraulic wash arms, Flexi-Safe load geometry, and 42dB acoustic shielding: Jammed ceramic distributor disc, stripped reduction gears, or open synchronous micro-motor coil (~3.5–4.2 kΩ)..

To resolve error code D08: Inspect motorized alternating valve assembly beneath tub. Measure drive motor resistance (~3.5–4.2 kΩ). Verify disc rotates smoothly by hand. Press and hold the Start/Reset button for 4 seconds until drain pump initiates, allow pumpout to complete, then switch off.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Sauter code D08 persists, the physical component causing On Sauter dishwashers featuring Saveurs alternating hydraulic wash arms, Flexi-Safe load geometry, and 42dB acoustic shielding: Jammed ceramic distributor disc, stripped reduction gears, or open synchronous micro-motor coil (~3.5–4.2 kΩ). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.