Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Zerowatt AL03
FAQ TREEWhat does error code AL03 mean on a Zerowatt appliance?
Zerowatt error code AL03 indicates: Zerowatt ZD / Space / CompactLine Dishwasher: Drain evacuation alarm AL03; sump fails to empty completely during intermediate rinse drain phase..
What is the root cause of Zerowatt error code AL03?
The primary root cause for Zerowatt code AL03 is: On Zerowatt dishwashers powered by CompactLine hydraulic wash circuit, mechanical water pressure regulation, and micro-switch anti-flood float protection: Heavy grease clogs in drain hose, sink siphon nipple blocked, or drain pump motor winding weakened (~160–220 Ω)..
How do I fix or resolve Zerowatt error code AL03?
To resolve error code AL03: Disconnect drain hose from under-sink siphon and verify clear bore. Flush drain hose with warm water. Measure pump motor resistance (~160–220 Ω). Hold Start button for 5 seconds until the program run LED stops blinking, close the door to complete drain, then power off.
Is it safe to clear Zerowatt error code AL03 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Zerowatt code AL03 persists, the physical component causing On Zerowatt dishwashers powered by CompactLine hydraulic wash circuit, mechanical water pressure regulation, and micro-switch anti-flood float protection: Heavy grease clogs in drain hose, sink siphon nipple blocked, or drain pump motor winding weakened (~160–220 Ω). must be inspected or replaced.
How do I test electrical resistance for Zerowatt code AL03 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Zerowatt code AL03?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



