Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Airlux ER31
FAQ TREEWhat does error code ER31 mean on a Airlux appliance?
Airlux error code ER31 indicates: Airlux Élite / Domino / Vision Induction and Aspirating Cooktop: Diagnostic fault code ER31 registered by the microcomputer controller. Power module variant coding invalid or unconfigured..
What is the root cause of Airlux error code ER31?
The primary root cause for Airlux code ER31 is: On Airlux appliances engineered with high-power electromagnetic induction coils, pan detection resonance circuitry, and sensitive capacitive touch slider controls: unconfigured spare part board installed. Metrological tolerance verification: nominal NTC thermistor 10.0 kΩ at 25°C, 32.0 kΩ at 0°C..
How do I fix or resolve Airlux error code ER31?
To resolve error code ER31: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure sensor resistance across probe pins (expected ~10 kΩ at 25°C). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Cut off the dedicated 32A cooktop circuit breaker for 60 seconds. Restore power, wait for display initialization to complete, then press and hold the Key Lock sensor for 4 seconds until the confirmation beep sounds.
Is it safe to clear Airlux error code ER31 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Airlux code ER31 persists, the physical component causing On Airlux appliances engineered with high-power electromagnetic induction coils, pan detection resonance circuitry, and sensitive capacitive touch slider controls: unconfigured spare part board installed. Metrological tolerance verification: nominal NTC thermistor 10.0 kΩ at 25°C, 32.0 kΩ at 0°C. must be inspected or replaced.
How do I test electrical resistance for Airlux code ER31 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Airlux code ER31?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?