Bompani F08

Bompani error code F08 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F08 signaled by internal electronics. Core food temperature probe sensing circuit open, shorted, or out of allowable calibration range.

The primary root cause for Bompani code F08 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Internal thermistor lead broken inside probe needle, jack socket contacts deformed, or lead cable pinched Multimeter diagnostic parameter: probe sensor nominal 10.0 kΩ at 25°C (NTC) or 1000 Ω (PT1000); jack socket contact resistance <0.2 Ω..

To resolve error code F08: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: plug probe into jack and measure resistance across socket terminals while flexing sensor cable. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F08 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Internal thermistor lead broken inside probe needle, jack socket contacts deformed, or lead cable pinched Multimeter diagnostic parameter: probe sensor nominal 10.0 kΩ at 25°C (NTC) or 1000 Ω (PT1000); jack socket contact resistance <0.2 Ω. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.