Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bompani F13
FAQ TREEWhat does error code F13 mean on a Bompani appliance?
Bompani error code F13 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F13 signaled by internal electronics. Lower bottom bake heating element open circuit or high resistance (1300W, nominal 38-44 Ω).
What is the root cause of Bompani error code F13?
The primary root cause for Bompani code F13 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Internal heating spiral burned open, thermal insulation sagging, or spade connector scorched by heat Multimeter diagnostic parameter: nominal resistance 38 Ω to 44 Ω at 20°C; infinite resistance indicates open circuit breakdown..
How do I fix or resolve Bompani error code F13?
To resolve error code F13: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: gain access to lower chassis housing and measure resistance directly across the bottom element spades. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.
Is it safe to clear Bompani error code F13 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F13 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Internal heating spiral burned open, thermal insulation sagging, or spade connector scorched by heat Multimeter diagnostic parameter: nominal resistance 38 Ω to 44 Ω at 20°C; infinite resistance indicates open circuit breakdown. must be inspected or replaced.
How do I test electrical resistance for Bompani code F13 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Bompani code F13?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?