Bompani F24

Bompani error code F24 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F24 signaled by internal electronics. Microcontroller internal software watchdog reset loop or DC logic voltage ripple disturbance.

The primary root cause for Bompani code F24 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Filter capacitor dried out in switch-mode power supply, high electrical noise from relay arc, or MCU failure Multimeter diagnostic parameter: +5.0V DC regulated logic rail stable within ±2% (4.90V to 5.10V DC); AC ripple voltage <30 mV RMS..

To resolve error code F24: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: measure DC output voltage and AC millivolt ripple across logic filter capacitors on main control board. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F24 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Filter capacitor dried out in switch-mode power supply, high electrical noise from relay arc, or MCU failure Multimeter diagnostic parameter: +5.0V DC regulated logic rail stable within ±2% (4.90V to 5.10V DC); AC ripple voltage <30 mV RMS. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.