Bompani F06

Bompani error code F06 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F06 signaled by internal electronics. Tangential cooling blower motor stall or speed sensor tachometer feedback missing (<600 RPM).

The primary root cause for Bompani code F06 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Cooling fan motor bearing seized with grease, thermal fuse open in fan winding, or Hall sensor open Multimeter diagnostic parameter: tangential motor winding resistance nominal 160 Ω to 220 Ω at 20°C; Hall sensor pulses 20-60 Hz at 5V DC..

To resolve error code F06: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: measure resistance across fan motor winding pins (expect 160-220 Ω) and spin rotor freely by hand. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F06 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Cooling fan motor bearing seized with grease, thermal fuse open in fan winding, or Hall sensor open Multimeter diagnostic parameter: tangential motor winding resistance nominal 160 Ω to 220 Ω at 20°C; Hall sensor pulses 20-60 Hz at 5V DC. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.