Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bompani F14
FAQ TREEWhat does error code F14 mean on a Bompani appliance?
Bompani error code F14 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F14 signaled by internal electronics. Electronic power PCB enclosure ambient temperature sensor over-temperature (>85°C detected).
What is the root cause of Bompani error code F14?
The primary root cause for Bompani code F14 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Cabinet ventilation slots blocked, oven cooling air intake obstructed, or tangential fan low speed Multimeter diagnostic parameter: PCB ambient NTC resistance nominal 10.0 kΩ at 25°C, drops below 1.1 kΩ when enclosure reaches 85°C..
How do I fix or resolve Bompani error code F14?
To resolve error code F14: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: measure ambient thermistor resistance on power board and verify tangential cooling fan airflow pressure. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.
Is it safe to clear Bompani error code F14 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F14 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Cabinet ventilation slots blocked, oven cooling air intake obstructed, or tangential fan low speed Multimeter diagnostic parameter: PCB ambient NTC resistance nominal 10.0 kΩ at 25°C, drops below 1.1 kΩ when enclosure reaches 85°C. must be inspected or replaced.
How do I test electrical resistance for Bompani code F14 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Bompani code F14?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?