Bompani F23

Bompani error code F23 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F23 signaled by internal electronics. Door interlock contact microswitch status mismatch between primary safety and secondary sense lines.

The primary root cause for Bompani code F23 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Door hinge sag misaligning striker pin, deformed switch actuator leaf, or microswitch internal carbon fouling Multimeter diagnostic parameter: door closed contact resistance <0.1 Ω across both switches; door open state must read open circuit (>10 MΩ)..

To resolve error code F23: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: test continuity of primary and secondary microswitches simultaneously while opening and closing the oven door. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F23 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Door hinge sag misaligning striker pin, deformed switch actuator leaf, or microswitch internal carbon fouling Multimeter diagnostic parameter: door closed contact resistance <0.1 Ω across both switches; door open state must read open circuit (>10 MΩ). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.