Bompani F02

Bompani error code F02 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F02 signaled by internal electronics. Cavity temperature sensor PT1000 short circuit (<750 Ω at 20°C ambient).

The primary root cause for Bompani code F02 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Sensor leads pinched against oven metal chassis or conductive moisture ingress inside probe casing Multimeter diagnostic parameter: measured resistance below 750 Ω indicates internal or wiring short circuit (nominal 1080 Ω at 20°C)..

To resolve error code F02: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: check resistance between sensor pins and from each pin to oven chassis earth (>100 MΩ required). Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F02 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Sensor leads pinched against oven metal chassis or conductive moisture ingress inside probe casing Multimeter diagnostic parameter: measured resistance below 750 Ω indicates internal or wiring short circuit (nominal 1080 Ω at 20°C). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.