Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bompani F15
FAQ TREEWhat does error code F15 mean on a Bompani appliance?
Bompani error code F15 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F15 signaled by internal electronics. Rotisserie spit motor drive circuit fault or mechanical gear transmission stall.
What is the root cause of Bompani error code F15?
The primary root cause for Bompani code F15 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Spit drive reduction gearbox stripped by overload, motor winding open circuit, or driving triac open Multimeter diagnostic parameter: rotisserie shaded-pole synchronous motor winding nominal 4.2 kΩ to 5.2 kΩ at 20°C; 230V AC drive voltage..
How do I fix or resolve Bompani error code F15?
To resolve error code F15: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: measure resistance across rotisserie motor leads (expect 4.2-5.2 kΩ) and verify 230V AC delivery when active. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.
Is it safe to clear Bompani error code F15 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F15 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: Spit drive reduction gearbox stripped by overload, motor winding open circuit, or driving triac open Multimeter diagnostic parameter: rotisserie shaded-pole synchronous motor winding nominal 4.2 kΩ to 5.2 kΩ at 20°C; 230V AC drive voltage. must be inspected or replaced.
How do I test electrical resistance for Bompani code F15 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Bompani code F15?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?