Bompani F10

Bompani error code F10 indicates: Bompani Serie Divina / Linea Built-in Multifunction Pyrolytic & Convection Oven: Operational diagnostic fault code F10 signaled by internal electronics. Heating element power relay contacts welded shut or feedback sensing circuit detects closed contact.

The primary root cause for Bompani code F10 is: On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: High inrush current arc pitted and fused relay contacts, or driving transistor shorted in conduction Multimeter diagnostic parameter: relay contact resistance must be infinite (>10 MΩ) when coil is unpowered; 0.0 Ω indicates welded contact..

To resolve error code F10: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: de-solder relay or isolate PCB traces and test resistance between normally-open switch terminals. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn oven selector knob to OFF position. Press and hold Temp and Timer buttons simultaneously for 5 seconds until 'rSt' flashes, then press Start to confirm memory wipe.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code F10 persists, the physical component causing On Bompani kitchen suites engineered with PT1000 cavity RTD sensor (1080 Ω at 20°C), bi-directional tangential cooling fan, motorized pyrolytic door lock, and 2300W convection circular element: High inrush current arc pitted and fused relay contacts, or driving transistor shorted in conduction Multimeter diagnostic parameter: relay contact resistance must be infinite (>10 MΩ) when coil is unpowered; 0.0 Ω indicates welded contact. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.