Bosch E01 — Dishwasher
[ACTIVE]Bosch Serie 4 / Serie 6 / Serie 8 ActiveWater & PerfectDry Zeolith: Critical power module failure E01; heating circuit relay contacts open or welded on the main control board.
On Bosch dishwashers: Relay driver triac damaged by heater inrush current, high contact resistance, or cold solder joints on the power board.
Disconnect mains power. Inspect power module in bottom right base. Measure heater resistance (nominal 19–22 Ω). Replace power module if relay is burnt. Hold Start/Reset key for 3 seconds until '0:01' appears, close door, allow 60s for drain completion, then power off.



