Bosch E02 — Dishwasher
[ACTIVE]Bosch Serie 4 / Serie 6 / Serie 8 ActiveWater & PerfectDry Zeolith: Auxiliary heating relay malfunction E02; secondary safety relay on power PCB fails to close during water heating phase.
On Bosch dishwashers: Defective auxiliary PCB relay coil, loose connector terminal on heater harness, or open circuit in heater safety loop.
Check wiring continuity between control board and heat pump terminals. Verify 12V DC coil activation voltage on PCB relay during wash cycle. Hold Start/Reset key for 3 seconds until '0:01' appears, close door, allow 60s for drain completion, then power off.



