Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: De Dietrich AL01
FAQ TREEWhat does error code AL01 mean on a De Dietrich appliance?
De Dietrich error code AL01 indicates: De Dietrich Prestige No Frost / DRS Multi-Zone Refrigerator: High temperature alarm in freezer compartment AL01; internal temperature rises above -9°C and audible buzzer sounds..
What is the root cause of De Dietrich error code AL01?
The primary root cause for De Dietrich code AL01 is: On De Dietrich refrigeration units featuring Prestige No Frost multi-sensor refrigeration, active preservation zone, and inverter compressor modulation: Door left ajar, magnetic perimeter gasket damaged, loss of refrigerant gas charge (R600a), or weak compressor pump..
How do I fix or resolve De Dietrich error code AL01?
To resolve error code AL01: Check door closure and verify magnetic seal airtightness with a paper strip. Allow 12 hours for stabilization if newly stocked. If compressor runs continuously without cooling, leak test system. Touch and hold the Alarm Acknowledge and Quick Chill icons for 8 seconds until the ICS chime signals buffer reset, then release.
Is it safe to clear De Dietrich error code AL01 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if De Dietrich code AL01 persists, the physical component causing On De Dietrich refrigeration units featuring Prestige No Frost multi-sensor refrigeration, active preservation zone, and inverter compressor modulation: Door left ajar, magnetic perimeter gasket damaged, loss of refrigerant gas charge (R600a), or weak compressor pump. must be inspected or replaced.
How do I test electrical resistance for De Dietrich code AL01 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing De Dietrich code AL01?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



