FAGOR d13

FAGOR error code D13 indicates: Fagor Eco Sensor / Innova / 1LV / 2LV Dishwasher: Water temperature overheating cutoff d13; sump temperature exceeds 75°C safety threshold during cycle..

The primary root cause for FAGOR code D13 is: On FAGOR dishwashers featuring Eco Sensor turbidity optoelectronics, Innova hydraulic distribution, and AquaStop active leak containment: Welded power relay contacts powering heater continuously, or short-circuited NTC thermistor..

To resolve error code D13: Disconnect power immediately. Measure heater relay contact continuity with power off (must be open). Test NTC resistance (~47 kΩ at 25°C). Press and hold the Start/Stop key for 5 seconds until the program indicator light clears and drain pump runs, then switch off.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if FAGOR code D13 persists, the physical component causing On FAGOR dishwashers featuring Eco Sensor turbidity optoelectronics, Innova hydraulic distribution, and AquaStop active leak containment: Welded power relay contacts powering heater continuously, or short-circuited NTC thermistor. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.