Iberna Er07

Iberna error code ER07 indicates: Iberna IB / Classic Convection & Pyrolytic Oven: Food meat probe circuit fault Er07; internal core thermometer probe reads short-circuited or out-of-scale temperature..

The primary root cause for Iberna code ER07 is: On Iberna ovens featuring Classic convection heating elements, rotary thermostat regulation, and tangential cooling airflow: Liquid grease ingress inside meat probe jack socket on cavity wall, punctured probe silicone cord, or shorted connector..

To resolve error code ER07: Unplug meat probe from wall jack. Clean socket contact pins with isopropyl alcohol. Measure probe resistance with multimeter (~10 kΩ or ~1000 Ω depending on type). Turn thermostat and selector dials to 0, switch off main breaker for 60 seconds, restore circuit and set clock time.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Iberna code ER07 persists, the physical component causing On Iberna ovens featuring Classic convection heating elements, rotary thermostat regulation, and tangential cooling airflow: Liquid grease ingress inside meat probe jack socket on cavity wall, punctured probe silicone cord, or shorted connector. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.