Ignis F01

Ignis error code F01 indicates: Ignis IGT AirVented & Condenser Tumble Dryer: Drum drive motor relay or triac failure F01; power PCB detects uncommanded drum rotation or shorted motor driver..

The primary root cause for Ignis code F01 is: On Ignis tumble dryers (Ignis heavy-duty electromechanical chassis and Arcadia / L1373 hybrid control architecture): Welded motor start relay contacts on control board, or short-circuited motor triac semiconductor..

To resolve error code F01: Disconnect mains power. Measure resistance across motor driver triac terminals (short = 0 Ω). Inspect power board for scorched relay pads. Press and hold Start key for 4 seconds, clear lint trap and reset high-limit safety thermostat.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Ignis code F01 persists, the physical component causing On Ignis tumble dryers (Ignis heavy-duty electromechanical chassis and Arcadia / L1373 hybrid control architecture): Welded motor start relay contacts on control board, or short-circuited motor triac semiconductor. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.